Details
| Titel in Übersetzung | Measurement of rotational workpieces by diffraction patterns |
|---|---|
| Originalsprache | Deutsch |
| Seiten (von - bis) | 83-91 |
| Seitenumfang | 9 |
| Fachzeitschrift | Technisches Messen |
| Jahrgang | 63 |
| Ausgabenummer | 3 |
| Publikationsstatus | Veröffentlicht - März 1996 |
| Extern publiziert | Ja |
Abstract
From the shadow of a workpiece recorded by a CCD-sensor, its geometric profile can be determined. This profile mar be determined to a few microns using the Fresnel-diffraction-fringes at the shadow border, when the workpiece is illuminated with parallel monochromatic radiation. This measurement principle is used by a measurement system to measure workpieces produced by a lathe. The set-up, the image analysis and the calibration of this system are presented. Finally, using the measurement results of diameter and length, the advantages, specific problems, open questions and further applications of this optical measurement method are discussed.
ASJC Scopus Sachgebiete
- Physik und Astronomie (insg.)
- Instrumentierung
- Ingenieurwesen (insg.)
- Elektrotechnik und Elektronik
Zitieren
- Standard
- Harvard
- Apa
- Vancouver
- BibTex
- RIS
in: Technisches Messen, Jahrgang 63, Nr. 3, 03.1996, S. 83-91.
Publikation: Beitrag in Fachzeitschrift › Artikel › Forschung › Peer-Review
}
TY - JOUR
T1 - Vermessung von Drehteilen durch Beugungsmusteranalyse
AU - Ackermann, Helmut
AU - Korthals, Jörn
AU - Overmeyer, Ludger
PY - 1996/3
Y1 - 1996/3
N2 - From the shadow of a workpiece recorded by a CCD-sensor, its geometric profile can be determined. This profile mar be determined to a few microns using the Fresnel-diffraction-fringes at the shadow border, when the workpiece is illuminated with parallel monochromatic radiation. This measurement principle is used by a measurement system to measure workpieces produced by a lathe. The set-up, the image analysis and the calibration of this system are presented. Finally, using the measurement results of diameter and length, the advantages, specific problems, open questions and further applications of this optical measurement method are discussed.
AB - From the shadow of a workpiece recorded by a CCD-sensor, its geometric profile can be determined. This profile mar be determined to a few microns using the Fresnel-diffraction-fringes at the shadow border, when the workpiece is illuminated with parallel monochromatic radiation. This measurement principle is used by a measurement system to measure workpieces produced by a lathe. The set-up, the image analysis and the calibration of this system are presented. Finally, using the measurement results of diameter and length, the advantages, specific problems, open questions and further applications of this optical measurement method are discussed.
UR - http://www.scopus.com/inward/record.url?scp=1542784369&partnerID=8YFLogxK
M3 - Artikel
AN - SCOPUS:1542784369
VL - 63
SP - 83
EP - 91
JO - Technisches Messen
JF - Technisches Messen
SN - 0171-8096
IS - 3
ER -