Details
| Originalsprache | Englisch |
|---|---|
| Seiten (von - bis) | 1005-1010 |
| Seitenumfang | 6 |
| Fachzeitschrift | Journal of Environmental Sciences |
| Jahrgang | 16 |
| Ausgabenummer | 6 |
| Publikationsstatus | Veröffentlicht - 1 Dez. 2004 |
Abstract
Modeling for nitritation process was discussed and analyzed quantlitatively for the factors that influence nitrite accumulation. The results indicated that pH, inorganic carbon source and Hydraulic Retention Time (HRT) as well as biomass concentration are the main factors that influenced the conversion ratio of ammonium to nitrite. A constant high pH can lead to a high nitritation rate and results in high conversion ratio on condition that free ammonia inhibition do not happen. In a CSTR system, without pH control, this conversion ratio can be monitored by pH variation in the reactor. The pH goes down far from the inlet level means a strongly nitrite accumulation. High concentration of alkalinity can promoted the conversion ratio by means of accelerating the nitritation rate through providing sufficient inorganic carbon source (carbon dioxide). When inorganic carbon source was depleted, the nitritation process stopped. HRT adjustment could be an efficient way to make the nitritation system run more flexible, which to some extent can meet the requirements of the fluctuant of inlet parameters such as ammonium concentration, pH, and temperature and so on. Biomass concentration is the key point, especially for a CSTR system in steady state, which was normally circumscribed by the characteristics of bacteria and may also affected by aeration mode and can be increased by prolonging the HRT on the condition of no nitrate accumulation when no recirculation available. The higher the biomass concentration is, the better the nitrite accumulation can be obtained.
ASJC Scopus Sachgebiete
- Umweltwissenschaften (insg.)
- Environmental engineering
- Umweltwissenschaften (insg.)
- Umweltchemie
- Umweltwissenschaften (insg.)
- Allgemeine Umweltwissenschaft
Zitieren
- Standard
- Harvard
- Apa
- Vancouver
- BibTex
- RIS
in: Journal of Environmental Sciences, Jahrgang 16, Nr. 6, 01.12.2004, S. 1005-1010.
Publikation: Beitrag in Fachzeitschrift › Artikel › Forschung › Peer-Review
}
TY - JOUR
T1 - Model-based evaluation on the conversion ratio of ammonium to nitrite in a nitritation process for ammonium-rich wastewater treatment
AU - Li, Xiao Ming
AU - Yang, Qi
AU - Zeng, Guang Ming
AU - Cornelius, A.
AU - Rosenwinkel, K. H.
AU - Kunst, S.
AU - Weichgrebe, D.
PY - 2004/12/1
Y1 - 2004/12/1
N2 - Modeling for nitritation process was discussed and analyzed quantlitatively for the factors that influence nitrite accumulation. The results indicated that pH, inorganic carbon source and Hydraulic Retention Time (HRT) as well as biomass concentration are the main factors that influenced the conversion ratio of ammonium to nitrite. A constant high pH can lead to a high nitritation rate and results in high conversion ratio on condition that free ammonia inhibition do not happen. In a CSTR system, without pH control, this conversion ratio can be monitored by pH variation in the reactor. The pH goes down far from the inlet level means a strongly nitrite accumulation. High concentration of alkalinity can promoted the conversion ratio by means of accelerating the nitritation rate through providing sufficient inorganic carbon source (carbon dioxide). When inorganic carbon source was depleted, the nitritation process stopped. HRT adjustment could be an efficient way to make the nitritation system run more flexible, which to some extent can meet the requirements of the fluctuant of inlet parameters such as ammonium concentration, pH, and temperature and so on. Biomass concentration is the key point, especially for a CSTR system in steady state, which was normally circumscribed by the characteristics of bacteria and may also affected by aeration mode and can be increased by prolonging the HRT on the condition of no nitrate accumulation when no recirculation available. The higher the biomass concentration is, the better the nitrite accumulation can be obtained.
AB - Modeling for nitritation process was discussed and analyzed quantlitatively for the factors that influence nitrite accumulation. The results indicated that pH, inorganic carbon source and Hydraulic Retention Time (HRT) as well as biomass concentration are the main factors that influenced the conversion ratio of ammonium to nitrite. A constant high pH can lead to a high nitritation rate and results in high conversion ratio on condition that free ammonia inhibition do not happen. In a CSTR system, without pH control, this conversion ratio can be monitored by pH variation in the reactor. The pH goes down far from the inlet level means a strongly nitrite accumulation. High concentration of alkalinity can promoted the conversion ratio by means of accelerating the nitritation rate through providing sufficient inorganic carbon source (carbon dioxide). When inorganic carbon source was depleted, the nitritation process stopped. HRT adjustment could be an efficient way to make the nitritation system run more flexible, which to some extent can meet the requirements of the fluctuant of inlet parameters such as ammonium concentration, pH, and temperature and so on. Biomass concentration is the key point, especially for a CSTR system in steady state, which was normally circumscribed by the characteristics of bacteria and may also affected by aeration mode and can be increased by prolonging the HRT on the condition of no nitrate accumulation when no recirculation available. The higher the biomass concentration is, the better the nitrite accumulation can be obtained.
KW - Conversion ratio
KW - Modeling analysis
KW - Nitritation process
KW - Nitrite accumulation
UR - http://www.scopus.com/inward/record.url?scp=21844479855&partnerID=8YFLogxK
M3 - Article
C2 - 15900739
AN - SCOPUS:21844479855
VL - 16
SP - 1005
EP - 1010
JO - Journal of Environmental Sciences
JF - Journal of Environmental Sciences
SN - 1001-0742
IS - 6
ER -