TY - JOUR

T1 - Key properties of Ni-Mn-Ga based single crystals grown with the SLARE technique

AU - Rolfs, Katharina

AU - Chmielus, Markus

AU - Guldbakke, Jan M.

AU - Wimpory, Robert C.

AU - Raatz, Annika

AU - Petry, Winfried

AU - Müllner, Peter

AU - Schneider, Rainer

PY - 2012/7/23

Y1 - 2012/7/23

N2 - Magnetic shape memory alloys (MSMAs), exhibit large strains and hence are materials, which could substitute giant magnetostrictive and piezoelectrical materials in actuating devices. The actuation stress needed to induce the strain is much lower than in other actuator materials. Since the strain can be induced without phase transformation by a magnetic field, the development of actuators with high working frequencies is possible. However, for reasonable applications, large strains have to be induced with small magnetic fields. Up to now repeatable magnetically induced strains of 5-10% in magnetic fields of less than 500 mT have been achieved only in single crystals. The production of Ni-Mn-Ga based single crystals is difficult and time consuming. The crystal quality is affected by porosity and impurities. With the Bridgeman based method called Slag Remelting and Encapsulation (SLARE) single crystalline ingots of Ni-Mn-Ga, Ni-Mn-Ga-Fe, and Ni-Mn-Ga-Co of high quality were grown and characterized. The results show that MSMA properties depend on the position within the single crystalline rods due to a composition gradient. The influence of surface treatment demonstrates that the decrease of surface roughness leads to a decrease of twinning stress. MSMAs with twinning stresses above 1 MPa show a magnetic field induced strain (MFIS) when tilting is not restricted by constraints. Softer samples can adapt to constraints much better and show large MFIS. Substituting Ni by Fe and Co, shifted the phase transitions successfully to higher temperatures. Ni-Mn-Ga alloyed with up to 6 at.% Co showed three different martensite structures: a non-modulated tetragonal structure, a modulated tetragonal structure, showing the same behavior as Ni-Mn-Ga with identical structures and a non-modulated orthorhombic structure with a stress-strain-behavior explainable by the double twinning mechanism.

AB - Magnetic shape memory alloys (MSMAs), exhibit large strains and hence are materials, which could substitute giant magnetostrictive and piezoelectrical materials in actuating devices. The actuation stress needed to induce the strain is much lower than in other actuator materials. Since the strain can be induced without phase transformation by a magnetic field, the development of actuators with high working frequencies is possible. However, for reasonable applications, large strains have to be induced with small magnetic fields. Up to now repeatable magnetically induced strains of 5-10% in magnetic fields of less than 500 mT have been achieved only in single crystals. The production of Ni-Mn-Ga based single crystals is difficult and time consuming. The crystal quality is affected by porosity and impurities. With the Bridgeman based method called Slag Remelting and Encapsulation (SLARE) single crystalline ingots of Ni-Mn-Ga, Ni-Mn-Ga-Fe, and Ni-Mn-Ga-Co of high quality were grown and characterized. The results show that MSMA properties depend on the position within the single crystalline rods due to a composition gradient. The influence of surface treatment demonstrates that the decrease of surface roughness leads to a decrease of twinning stress. MSMAs with twinning stresses above 1 MPa show a magnetic field induced strain (MFIS) when tilting is not restricted by constraints. Softer samples can adapt to constraints much better and show large MFIS. Substituting Ni by Fe and Co, shifted the phase transitions successfully to higher temperatures. Ni-Mn-Ga alloyed with up to 6 at.% Co showed three different martensite structures: a non-modulated tetragonal structure, a modulated tetragonal structure, showing the same behavior as Ni-Mn-Ga with identical structures and a non-modulated orthorhombic structure with a stress-strain-behavior explainable by the double twinning mechanism.

UR - http://www.scopus.com/inward/record.url?scp=84864692251&partnerID=8YFLogxK

U2 - 10.1002/adem.201200065

DO - 10.1002/adem.201200065

M3 - Review article

AN - SCOPUS:84864692251

VL - 14

SP - 614

EP - 635

JO - Advanced Engineering Materials

JF - Advanced Engineering Materials

SN - 1438-1656

IS - 8

ER -