Details
| Originalsprache | Englisch |
|---|---|
| Qualifikation | Doktor der Ingenieurwissenschaften |
| Gradverleihende Hochschule | |
| Betreut von |
|
| Datum der Verleihung des Grades | 17 Apr. 2018 |
| Erscheinungsort | Garbsen |
| ISBNs (Print) | 9783959002066, 3959002068 |
| ISBNs (E-Book) | 978-3-95900-289-9 |
| Publikationsstatus | Veröffentlicht - 2018 |
Abstract
Zitieren
- Standard
- Harvard
- Apa
- Vancouver
- BibTex
- RIS
Garbsen, 2018. 120 S.
Publikation: Qualifikations-/Studienabschlussarbeit › Dissertation
}
TY - BOOK
T1 - Borescopic 3D inspection of complex geometries
AU - Schlobohm, Jochen
N1 - Doctoral thesis
PY - 2018
Y1 - 2018
N2 - This work gives an overview of borescopic 3D inspection. It focuses on the use of fringe projection profilometry with a borescope for image projection and a chip-on-tip camera for image acquisition. It starts with a short history of endoscopes and covers the state of the art of 3D optical measurement and endoscopic inspection systems. The main part addresses the development of a rigid borescopic fringe projection system. The high distortion of a borescope and its flexible shaft yield new challenges towards the calibration of such a measurement system. Major contributions where made towards the analysis and compensation of aberrations caused by bending of the rigid borescope. Hence a method for orientation sensitive calibration was introduced. Additionally, the topic of calibrating a serial kinematic, used to position the measurement system relative to a specimen, is covered. Finally, this work concludes with measurement results and an outlook for further research.
AB - This work gives an overview of borescopic 3D inspection. It focuses on the use of fringe projection profilometry with a borescope for image projection and a chip-on-tip camera for image acquisition. It starts with a short history of endoscopes and covers the state of the art of 3D optical measurement and endoscopic inspection systems. The main part addresses the development of a rigid borescopic fringe projection system. The high distortion of a borescope and its flexible shaft yield new challenges towards the calibration of such a measurement system. Major contributions where made towards the analysis and compensation of aberrations caused by bending of the rigid borescope. Hence a method for orientation sensitive calibration was introduced. Additionally, the topic of calibrating a serial kinematic, used to position the measurement system relative to a specimen, is covered. Finally, this work concludes with measurement results and an outlook for further research.
M3 - Doctoral thesis
SN - 9783959002066
SN - 3959002068
T3 - Berichte aus dem imr
CY - Garbsen
ER -